Gravity-Centrifugal-Power-Motor :: essays research papers

SCM-VariationGravity-Centrifugal-Power-MotorObjectivesAt chapter Swing-Circuit-Motor (SCM) above, a design was worked out corresponding to build-up of a loop-swing. There, two axis were demanded (system- and excenter-axis) and two wheels did turn within each other. So this will be a rather difficult technical construction. By this chapter now shall be examined, how effect of building-up mechancal oscillations could be realized easier. So still one axis should be neccessary, nevertheless masses should incite ilk at uneven movement of pendulum, above this phase shifting by intermediate storage of forces must be guaranteed. Pendulum with radiate suspensionAt previous chapter Mechanical Oscillating Circuit Harald Chmela did mention example of a pendulum with radially working spring, like schematically luffn once more at picture EV SKM 31 upside. Around system axis (SA) a pendulum, here called rotor arm (RT, German Rotortrger), can swing. At the rotor arm effective mass (MP) can gl ide inside and outside. That radial movements are limited resp. controlled by a spring element (FE, German Federelement). Potential slide fastener of level is transformed into kinetic skill at downward-phase, opposite energy of movement is re-transformed into energy of high level at upward-phase. In addition, might is stored into spring intermediately, so some later power is restored into pendulums oscillation. Mass will move at an U-shaped cover up. Mass will show maximum speed at its lowest point of track (A) and at that place will press down spring at its maximum. Following loosening of spring will show analog relations of forces, based at symmetry, so this mechanized oscillation will be stable (no grinding assumed). Effect of building-up oscillations can only be achieved, if symmetry is broken. This could be do e.g. as shown at picture EV SKM 31 downside. Asymmetric trackTension of spring downside should have to be stored for a short time, e.g. each mechanicsm could al low relaxation of spring some later (B). Counter stored energy then would exist less forces (resulting force of gravity power and outward-developing power), showing upward more and more. Power of spring afterward could move mass easier and faster towards upward-inside (C). Angles speed thus will be intensify and mass will be brought to higher level (D) than starting level. This mechanical oscillating circuit thus will be build-up without input of energy from outside. Progressive suspensionBy this concept an asymmetric track is achieved. However, this pendulum singe resp. effect of build-up oscillations is technically usable only if a momentum is achieved at a constant turning shaft.